1/4-20 tap drill

The usual shop tap drill for a 1/4-20 UNC hole is a #7, 0.2010 in. That is a 75% engagement estimate for the ASME B1.1 1/4-20 thread, not a clearance hole, and the title is the thread itself rather than a generic “tap drill size” chart.

1/4-20 UNC — usual 75% tap drill

A 1/4-20 UNC thread has a basic major diameter of 0.2500 in and 20 threads per inch (pitch 0.050 in). The 75% estimate D − 0.97425 × 0.050 in is 0.2013 in; the nearest standard drill is #7 (0.2010 in). The fine companion is 1/4-28 UNF, usually drilled #3 (0.2130 in).

A tap drill is smaller than the fastener so a tap can cut the internal thread. If the bolt should pass straight through, use the clearance hole chart instead. Percent of thread, the material, and the tap maker’s chart can justify a different drill, especially in tough alloys. Pipe and taper threads are not listed here.

Sources

  • ASME B1.1, Unified Inch Screw Threads, for basic major diameter and TPI of Unified threads, including 1/4-20 UNC, #10-32 UNF, and #8-32 UNC.
  • The 75% engagement shop estimate D − 0.97425 × pitch, with the usual nearest standard number, letter, or fractional drill. The standard specifies the thread, not a mandatory drill letter. Metric recommended drills follow the same 75%-class idea (often D − pitch, ISO 2306 / shop practice).

Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.