Rivet size chart

The usual workshop “pop” rivet is a break-stem blind rivet. Standard body diameters are shared across IFI and ISO product standards. Grip range — the thickness the rivet can clamp — is a property of each length and alloy, and is read from the manufacturer’s part data, not guessed from diameter alone.

Standard blind-rivet diameters

Common inch nameNominal diameter (in)Nominal diameter (mm)Notes
3/32 in0.0942.4Light sheet, small heads
1/8 in0.1253.2The most common general-purpose diameter
5/32 in0.1564.0Heavier sheet than 1/8 in
3/16 in0.1884.8Common in thicker or structural light fabrication
1/4 in0.2506.4Large-diameter blind rivets

These are the standard nominal diameters used for open-end break-stem blind rivets in inch and metric practice (IFI-114 and the ISO 15973 / 15977 family). Exact body tolerance, head style (dome, large flange, countersunk), and material (aluminium, steel, stainless, copper, and so on) are product-standard items.

Grip range, holes, and mandrels

Grip range is printed on the packet or in the maker’s table as a min–max thickness. A rivet that is too short will not form a full secondary head; one that is too long may not break the stem correctly or may remain proud. Do not invent a grip from the rivet’s overall length alone — two rivets with the same diameter can have different grip ranges.

The recommended hole is slightly larger than the rivet body and is given by the manufacturer or the product standard for that diameter and material. It is a clearance hole for the body, not a tap drill and not a wood-screw pilot. The mandrel (stem) is discarded after the rivet sets; required nose pieces follow the tool and the rivet series, not a wrench-size chart.

Sources

  • IFI-114, Break Mandrel Blind Rivets (Industrial Fasteners Institute), and the ISO 15973 / 15977 family of break-stem blind rivets, for the standard 2.4, 3.2, 4.0, 4.8, and 6.4 mm nominal diameters and the requirement that grip range be taken from the specific part.
  • Manufacturer installation data (for example POP / Stanley Engineered Fastening and other IFI-conforming lines) for hole size and grip range of a named rivet. Those figures are not reproduced here as a generic length-to-grip table.

Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.