Sheet metal screw sizes
Inch sheet-metal (tapping) screws use the same numbered basic diameters as machine screws, but they form or cut their own mating thread in sheet metal. Product types and threads are specified in ASME B18.6.4.
Number sizes and Type AB threads
The usual pointed tapping screw in light sheet metal is Type AB (a finer, sharper thread than the older Type A). Type B is a blunt-point threaded screw for heavier or pre-drilled sheet. Type C and thread-forming variants exist for specific materials; use the type marked on the packet, not a generic “sheet metal screw” assumption.
| Nominal size | Basic major diameter (in) | Basic major diameter (mm) | Typical Type AB threads per inch |
|---|---|---|---|
| #4 | 0.112 | 2.84 | 24 |
| #6 | 0.138 | 3.51 | 20 |
| #8 | 0.164 | 4.17 | 18 |
| #10 | 0.190 | 4.83 | 16 |
| #12 | 0.216 | 5.49 | 14 |
| #14 | 0.242 | 6.15 | 14 |
Basic diameters follow the standard US numbered-screw series (0.060 + n × 0.013 in). Type AB threads per inch are the usual ASME B18.6.4 values for that type. Other types (A, B, and so on) can have a different pitch — read the product standard or the maker’s data, not this Type AB column, for those screws.
A sheet-metal screw is not interchangeable with a machine screw of the same number: #8-32 is a machine thread (32 TPI) and will not match a #8 Type AB tapping screw (18 TPI). Pilot or clearance holes in sheet metal are set by the sheet thickness and the screw type; use the manufacturer’s recommended hole, not the wood-screw pilot chart and not a tapped UNC hole, unless the part is actually being tapped.
Sources
- ASME B18.6.4, Thread Forming and Thread Cutting Tapping Screws and Metallic Drive Screws (Inch Series) (and the tapping-screw portions historically associated with B18.6.3), for types, points, and Type AB pitches.
- Basic number-size diameters are the standard series also used in ASME B18.6.3 / B1.1 (0.060 in + n × 0.013 in).
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.