8-32 tap drill
The usual shop tap drill for a #8-32 UNC hole is a #29, 0.1360 in. #8-32 is the coarse Unified thread on the #8 major diameter of 0.1640 in; the fine companion is #8-36, which commonly uses the same #29 drill.
#8-32 UNC — usual 75% tap drill
A #8-32 UNC thread has a basic major diameter of 0.1640 in and 32 threads per inch. The 75% estimate is 0.1336 in; the usual standard drill is #29 (0.1360 in), slightly above that estimate and the size almost every shop chart lists. A #8 wood screw is 15 TPI and is not this thread.
A tap drill is smaller than the fastener so a tap can cut the internal thread. If the bolt should pass straight through, use the clearance hole chart instead. Percent of thread, the material, and the tap maker’s chart can justify a different drill, especially in tough alloys. Pipe and taper threads are not listed here.
Sources
- ASME B1.1, Unified Inch Screw Threads, for basic major diameter and TPI of Unified threads, including 1/4-20 UNC, #10-32 UNF, and #8-32 UNC.
- The 75% engagement shop estimate D − 0.97425 × pitch, with the usual nearest standard number, letter, or fractional drill. The standard specifies the thread, not a mandatory drill letter. Metric recommended drills follow the same 75%-class idea (often D − pitch, ISO 2306 / shop practice).
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.