Wall plug size chart (UK)
In UK masonry fixing, a plastic wall plug (often called a Rawlplug) is colour-coded by size. The figures below are Rawlplug’s published R-OLD data, not a Building Regulations table and not a translation of a US lag-shield or concrete-screw chart.
Look up a Rawlplug R-OLD colour
Rawlplug R-OLD published sizes
| Colour | Masonry hole diameter (mm) | Plug length (mm) | Screw diameter range (mm) |
|---|---|---|---|
| Yellow | 5 | 25 | 3.0–5.0 |
| Red | 6 | 35 | 3.5–5.5 |
| Brown | 7 | 45 | 5.0–6.0 |
Taken from Rawlplug’s R-OLD plastic expansion plug product data. Drill the stated hole, insert the plug, then tighten a screw in the published diameter range. Other brands, and other Rawlplug series (frame anchors, cavity fixings, insulation fixings), can use different colours or hole sizes — read that product’s data, not this table, for those fixings.
Rawlplug lists this R-OLD range for medium and lightweight applications in bases such as concrete and solid brick. Hollow block, plasterboard, and insulation need a different fixing. Screw length must also suit the fixture thickness plus the plug length; that is not a single official number and should follow the maker’s installation steps.
This is not a US page: it does not use number sizes as the primary rule, and it does not reuse lag-shield, wedge-anchor, or Tapcon data. For timber coach screws, see the separate coach screw page. For plasterboard on studs, see plasterboard screw sizes — do not use a masonry plug in a hollow plasterboard cavity unless the product is made for that substrate.
Sources
- Rawlplug, R-OLD Plastic expansion plug product data: yellow 5 mm hole, 25 mm long, screws 3.0–5.0 mm; red 6 mm hole, 35 mm long, screws 3.5–5.5 mm; brown 7 mm hole, 45 mm long, screws 5.0–6.0 mm. PDF: R-OLD product datasheet. Manufacturer site: rawlplug.com.
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.