BSF thread chart
British Standard Fine (BSF) is the fine 55-degree inch thread in BS 84:1956. It is the fine companion to Whitworth (BSW), not the UNF companion to UNC. Pitches differ: 1/4 BSF is 26 TPI, not 28 UNF, and 1/2 BSF is 16 TPI, not 20 UNF.
BS 84:1956 British Standard Fine (BSF)
| Nominal size (in) | TPI | Major diameter (in) | Major diameter (mm) | Pitch (in) |
|---|---|---|---|---|
| 3/16 | 32 | 0.1875 | 4.763 | 0.0313 |
| 1/4 | 26 | 0.2500 | 6.350 | 0.0385 |
| 5/16 | 22 | 0.3125 | 7.938 | 0.0455 |
| 3/8 | 20 | 0.3750 | 9.525 | 0.0500 |
| 7/16 | 18 | 0.4375 | 11.113 | 0.0556 |
| 1/2 | 16 | 0.5000 | 12.700 | 0.0625 |
| 9/16 | 16 | 0.5625 | 14.288 | 0.0625 |
| 5/8 | 14 | 0.6250 | 15.875 | 0.0714 |
| 3/4 | 12 | 0.7500 | 19.050 | 0.0833 |
| 7/8 | 11 | 0.8750 | 22.225 | 0.0909 |
| 1 | 10 | 1.0000 | 25.400 | 0.1000 |
BSF threads from BS 84:1956. These TPI values are not UNF (for example 1/4-26 BSF versus 1/4-28 UNF, 1/2-16 BSF versus 1/2-20 UNF), and the thread angle is 55 degrees, not 60. Use a BSF tap and nut, not a UNF or BSW part, on a BSF thread.
Sources
- BS 84:1956, Parallel screw threads of Whitworth form, British Standard Fine (BSF) series, for TPI and major diameters tabulated above.
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.