Coach screw sizes
In UK timber work a coach screw is a hex-head wood screw, usually to DIN 571. It is the closest everyday equivalent to a US lag screw, but the product standard, head sizes, and naming are not the same, so this page does not copy US lag-screw lead-hole percentages as if they were DIN rules.
DIN 571 hex-head dimensions
DIN 571 specifies a hexagon head, a threaded body for timber, and a gimlet or similar point. Common UK stock sizes are M6, M8, M10, and M12, in a range of lengths. Across-flats sizes on M10 and M12 are not the same as ISO 4014 hex bolts of those diameters.
| Thread d | Width across flats s, nominal (mm) | Nominal head height k (mm) | ds max / min (mm) |
|---|---|---|---|
| M6 | 10 | 4 | 6 / 5.52 |
| M8 | 13 | 5.5 | 8 / 7.42 |
| M10 | 17 | 7 | 10 / 9.42 |
| M12 | 19 | 8 | 12 / 11.3 |
| M16 | 24 | 10 | 16 / 15.3 |
| M20 | 30 | 13 | 20 / 19.3 |
DIN 571 hexagon head wood screws. Note M10 = 17 mm across flats and M12 = 19 mm, versus 16 mm and 18 mm on ISO 4014/4017 hex bolts. Use the DIN 571 spanner size, not the ISO bolt chart, on a coach screw. Values above are the standard’s nominal s and k and the listed ds limits.
Pilot holes in timber are required to avoid splitting, especially near ends and in hardwood, but DIN 571 itself is a product standard, not a timber-design code. Follow the timber designer or the manufacturer for hole size; do not treat the US AWC NDS lag-screw percentages on the US pilot hole page as a DIN 571 table. Length must suit the fixture plus a sensible embedment in the receiving timber; that embedment is a design choice, not a figure invented here.
Sources
- DIN 571, Hexagon head wood screws, for d, s (width across flats), k (head height), and ds limits. Public dimensional extract used for cell confirmation: Fuller Fasteners DIN 571 specifications.
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.