Plasterboard screw sizes (UK)
UK plasterboard is usually fixed with British Gypsum (or equivalent) bugle-head drywall screws. Length follows a simple published rule: board thickness plus a minimum penetration into the support. This is not the US IRC 5/8 in drywall rule, which lives on a separate page.
British Gypsum length rule
British Gypsum’s stated rule is: use a screw equal to the thickness of the board plus a minimum 10 mm penetration into Gypframe metal, or the thickness of the board plus a minimum 25 mm penetration into timber, using British Gypsum screws.
| Board thickness | Support | Minimum penetration | Minimum screw length (rule) | Common British Gypsum length |
|---|---|---|---|---|
| 12.5 mm | Gypframe metal | 10 mm into metal | 22.5 mm | 25 mm drywall or jack-point screw |
| 15 mm | Gypframe metal | 10 mm into metal | 25 mm | 25 mm (confirm the product for 15 mm board) |
| 12.5 mm | Timber | 25 mm into timber | 37.5 mm | 42 mm is often the next stocked length; 35 mm is used where the maker allows a shorter screw — follow the system specification |
| 15 mm | Timber | 25 mm into timber | 40 mm | 42 mm or 50 mm, per the system specification |
The minimum length column is board thickness plus British Gypsum’s published penetration. Stocked lengths in the last column are common products, not a second official table. Always use the length required by the specific White Book system.
British Gypsum drywall screws for this duty are typically 3.5 mm diameter bugle-head screws (black phosphate for the standard drywall range; jack-point screws are used for heavier gauge metal). Spacing is a system detail: British Gypsum’s general figures are 300 mm centres on partitions (200 mm at external angles), 230 mm in the field of a ceiling and 150 mm at board ends, and 150 mm on encasements — but the White Book specification for the system in use takes precedence.
Do not use the US drywall screw Type W / Type S and IRC 5/8 in figures on a UK plasterboard job, and do not use a masonry wall plug as the primary fixing of plasterboard to a stud.
Sources
- British Gypsum, “What screw lengths do I use for fixing to metal and timber?”: the screw should be the thickness of the board plus a minimum 10 mm penetration into Gypframe metal, or the thickness of the board plus a minimum 25 mm penetration into timber, using British Gypsum screws. British Gypsum FAQ.
- British Gypsum FAQ on screw fixing centres (partitions 300 mm, 200 mm at external angles; ceilings 230 mm in the field and 150 mm at ends; encasements 150 mm), with the White Book Specification Selector as the system-specific authority.
- British Gypsum product data sheets for Drywall Screws and Jack-Point Screws, for the 3.5 mm-class products and listed lengths.
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.