Drywall screw sizes
In US residential work, gypsum board is usually fastened with bugle-head screws made to ASTM C1002. The important choices are thread type (wood versus steel studs) and length, which is set by a minimum penetration rule, not by a single official “size chart.”
Type W, Type S, and penetration
ASTM C1002 distinguishes steel drill screws for gypsum board. In ordinary language, and in the International Residential Code fastener schedule:
- Type W (coarse thread) is for fastening to wood framing.
- Type S (finer thread, self-drilling or sharp point depending on the product) is for steel framing.
The 2021 International Residential Code, R702.3.5, requires Type W or Type S screws fastening gypsum to wood to penetrate the wood not less than 5/8 in, and screws fastening gypsum to steel to penetrate the steel not less than 3/8 in (the adopted code in a jurisdiction may amend this). Length is therefore board thickness plus that penetration, then rounded up to a commonly stocked length:
| Board thickness | Framing | Minimum penetration | Minimum screw length (rule) | Common stocked length |
|---|---|---|---|---|
| 1/2 in | Wood | 5/8 in into wood | 1-1/8 in | 1-1/4 in Type W coarse |
| 5/8 in | Wood | 5/8 in into wood | 1-1/4 in | 1-5/8 in Type W coarse |
| 1/2 in | Steel stud | 3/8 in through steel | 7/8 in | 1 in Type S (confirm the product) |
| 5/8 in | Steel stud | 3/8 in through steel | 1 in | 1-1/4 in Type S (confirm the product) |
Minimum lengths are board thickness plus the IRC penetration figure. Common stocked lengths are the usual next-larger lengths used in practice; they are not a separate IRC table. Always check the adopted code and the screw maker’s instructions.
Most interior drywall screws are a #6 bugle head (basic diameter 0.138 in, the same number-size diameter as a #6 machine or wood screw). #7, #8, and #10 screws are also sold, especially for thicker boards, ceilings, or heavier gauge steel. Coarse versus fine is about the stud material, not about “stronger threads” in the abstract.
This page is for US gypsum board on wood or steel studs. For UK plasterboard on timber or Gypframe, use the separate plasterboard screw sizes page, which uses British Gypsum’s length rule and does not reuse the IRC 5/8 in figure.
Sources
- 2021 International Residential Code (IRC), Section R702.3.5 (gypsum board fastener schedule / screw fastening), including the 5/8 in wood and 3/8 in steel penetration figures. The IRC is a model code; it applies only where adopted, and local amendments may change a limit.
- ASTM C1002, Standard Specification for Steel Self-Piercing Tapping Screws for Application of Gypsum Panel Products or Metal Plaster Bases to Wood Studs or Steel Studs, for Type W and Type S product distinctions.
- The Gypsum Association’s GA-216 application specification is the industry installation counterpart often cited alongside the IRC; use the edition referenced by the adopted code.
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.