#10 screw size
A #10 screw has a basic major diameter of 0.190 in (4.83 mm) in the standard US numbered-screw series. As with #8, the number names the diameter, not a single thread.
What “#10” actually shares — and what it does not
| Product | Basic major diameter | Typical thread | Usual hole if you are cutting or starting a thread | Usual through hole |
|---|---|---|---|---|
| #10 wood screw (ASME B18.6.1) | 0.190 in (major 0.183–0.194) | 13 TPI | Pilot — starting point, see the pilot chart (not a tap drill) | Shank clearance in the top piece if the joint should clamp |
| #10-24 machine screw (UNC) | 0.1900 in | 24 TPI | #25 tap drill (0.1495 in) | B18.2.8 normal: #2 (0.221 in) |
| #10-32 machine screw (UNF) | 0.1900 in | 32 TPI | #21 tap drill (0.1590 in) | Same clearance as #10-24 (the hole follows diameter, not pitch) |
| #10 Type AB sheet-metal screw | 0.190 in | 16 TPI typical | Maker’s recommended sheet hole, not a UNC tap drill | Only if the sheet is a clearance part, not the tapped sheet |
Basic diameter 0.190 in is 0.060 + 10 × 0.013. A #10 drywall screw is a gypsum tapping screw, not a #10-32 machine screw.
For a machine thread, the fine #10-32 is the everyday electronics and equipment thread; its tap drill is on the 10-32 tap drill page. The coarse companion is #10-24, usually drilled #25. Wood lead holes and plate clearance holes are on their own charts.
Sources
- ASME B18.6.1 for #10 wood-screw diameter and 13 TPI.
- ASME B1.1 / B18.6.3 for #10-24 UNC and #10-32 UNF (basic diameter 0.1900 in) and the usual #25 / #21 tap drills.
- ASME B18.2.8 for the #10 close / normal / loose clearance holes.
- ASME B18.6.4 for Type AB tapping-screw pitch (typically 16 TPI on #10).
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.