BA screw sizes

British Association (BA) threads are a small-diameter, metric-pitch series specified in BS 93. They turn up on instruments, electrical fittings, and older UK equipment. They are not UNC number sizes and not ISO metric coarse threads, even when a diameter looks close to M3 or M4.

BS 93:1951 British Association threads

DesignationPitch (mm)Major diameter (mm)Major diameter (in)
0 BA1.006.000.2362
1 BA0.905.300.2087
2 BA0.814.700.1850
3 BA0.734.100.1614
4 BA0.663.600.1417
5 BA0.593.200.1260
6 BA0.532.800.1102
7 BA0.482.500.0984
8 BA0.432.200.0866
9 BA0.391.900.0748
10 BA0.351.700.0669

Major diameters and pitches from BS 93:1951, the British Association thread. 2 BA and 4 BA are among the sizes still commonly encountered. The series is obsolete for new design in favour of ISO metric, but it remains the correct thread for servicing BA parts.

BA uses a 47.5-degree thread angle, not the 60-degree Unified or ISO angle and not the 55-degree Whitworth angle. Do not tap a BA hole with a metric or UNC tap of “about the same” diameter. For Whitworth and BSF, use their own pages.

Sources

  • BS 93:1951, Specification for British Association (B.A.) screw threads with tolerances for sizes 0 B.A. to 16 B.A., for the diameters and pitches tabulated above.

Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.