About Bolt Reference

A small reference site for common fastener specification charts and planning tools, with published sources stated on each page.

About this website

Bolt Reference (BoltReference.com) provides free specification charts and planning tools for bolts, screws, threads, tap drills, clearance holes, and pilot holes, plus a separate set of United Kingdom pages for wall plugs, coach screws, plasterboard screws, and BA / Whitworth / BSF threads. The aim is to make the published dimensions and the usual shop rules easier to check, without treating the site as a substitute for the standard, a manufacturer’s instructions, or an engineer’s specification.

The site is operated as a reference website. It is not a fastener manufacturer or retailer, a design firm, or a licensed contractor, and it does not sell the products mentioned in the notes.

What you can find here

  • US and shared charts for wood, machine, drywall, and sheet-metal screws, and for rivets
  • Metric bolt dimensions and an advisory metric torque lookup for ISO property classes 8.8, 10.9, and 12.9
  • Unified National Coarse (UNC) and ISO metric thread charts, with specific 1/4-20, 10-32, and 8-32 tap-drill pages
  • Clearance-hole and pilot-hole tools that distinguish a through hole from a tap drill or a lead hole
  • Separate UK pages for wall plugs, coach screws, plasterboard screws, BA, Whitworth, and BSF

Sources and limits

Dimensions are taken from the standards named on each page (for example ASME B1.1, B18.6.1, B18.2.8, ISO 262, ISO 724, ISO 4014, BS 84, BS 93, DIN 571). Where a figure is a shop estimate or a manufacturer’s product range — 75% tap drills, advisory torque, wood-screw starting pilots, Rawlplug colours, British Gypsum screw lengths — that is labeled as such. US customary rules and UK-only fixing names are never merged on the same tool. If a figure cannot be sourced, it is omitted rather than invented. Wheel-nut torque, wrench charts, and washer dimensions that collide with washing-machine searches are out of scope.

Contact

If you find an error or have a suggestion, please use the contact page. Email is listed as coming soon until an address is published there.

Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.