10-32 tap drill
The usual shop tap drill for a #10-32 UNF hole is a #21, 0.1590 in. #10-32 is the fine Unified thread on the #10 major diameter of 0.1900 in; the coarse companion is #10-24, usually drilled #25.
#10-32 UNF — usual 75% tap drill
A #10-32 UNF thread has a basic major diameter of 0.1900 in and 32 threads per inch (pitch 0.03125 in). The 75% estimate is 0.1596 in; the nearest standard drill is #21 (0.1590 in). Do not use a wood-screw or sheet-metal pilot in place of this tap drill when you are cutting a machine thread.
A tap drill is smaller than the fastener so a tap can cut the internal thread. If the bolt should pass straight through, use the clearance hole chart instead. Percent of thread, the material, and the tap maker’s chart can justify a different drill, especially in tough alloys. Pipe and taper threads are not listed here.
Sources
- ASME B1.1, Unified Inch Screw Threads, for basic major diameter and TPI of Unified threads, including 1/4-20 UNC, #10-32 UNF, and #8-32 UNC.
- The 75% engagement shop estimate D − 0.97425 × pitch, with the usual nearest standard number, letter, or fractional drill. The standard specifies the thread, not a mandatory drill letter. Metric recommended drills follow the same 75%-class idea (often D − pitch, ISO 2306 / shop practice).
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.