Whitworth thread chart (BSW)
British Standard Whitworth (BSW) is the coarse 55-degree inch thread in BS 84:1956. Some pitches match UNC, but not all: a 1/2 in Whitworth thread is 12 TPI, whereas 1/2-13 UNC is 13 TPI. The thread angle is 55 degrees, not the Unified 60 degrees.
BS 84:1956 British Standard Whitworth (BSW)
| Nominal size (in) | TPI | Major diameter (in) | Major diameter (mm) | Pitch (in) |
|---|---|---|---|---|
| 1/8 | 40 | 0.1250 | 3.175 | 0.0250 |
| 3/16 | 24 | 0.1875 | 4.763 | 0.0417 |
| 1/4 | 20 | 0.2500 | 6.350 | 0.0500 |
| 5/16 | 18 | 0.3125 | 7.938 | 0.0556 |
| 3/8 | 16 | 0.3750 | 9.525 | 0.0625 |
| 7/16 | 14 | 0.4375 | 11.113 | 0.0714 |
| 1/2 | 12 | 0.5000 | 12.700 | 0.0833 |
| 5/8 | 11 | 0.6250 | 15.875 | 0.0909 |
| 3/4 | 10 | 0.7500 | 19.050 | 0.1000 |
| 7/8 | 9 | 0.8750 | 22.225 | 0.1111 |
| 1 | 8 | 1.0000 | 25.400 | 0.1250 |
BSW threads from BS 84:1956. The 1/2 in row is 12 TPI, not the UNC 13 TPI. 1/4-20, 5/16-18, 3/8-16, 3/4-10, and 1-8 share TPI with UNC but still differ in thread angle (55° versus 60°) and in basic pitch/minor diameters — do not mix taps, dies, or nuts across the two systems.
Whitworth is obsolete for most new design, replaced by ISO metric, but it remains the correct thread on a great deal of UK plant, vehicle, and heritage work. The fine companion series is BSF, on a separate page. Pipe threads (BSPP / BSPT) are a different family and are not listed here.
Sources
- BS 84:1956, Parallel screw threads of Whitworth form, British Standard Whitworth (BSW) series, for TPI and major diameters tabulated above. The 55-degree Whitworth form is defined in that standard.
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.