#8 screw size
A #8 screw has a basic major diameter of 0.164 in (4.17 mm) in the standard US numbered-screw series. The thread is not the same on a wood screw, a machine screw, and a sheet-metal screw, so the number alone does not tell you which fastener you have.
What “#8” actually shares — and what it does not
| Product | Basic major diameter | Typical thread | Usual hole if you are cutting or starting a thread | Usual through hole |
|---|---|---|---|---|
| #8 wood screw (ASME B18.6.1) | 0.164 in (major 0.157–0.168) | 15 TPI | Pilot — starting point, see the pilot chart (not a tap drill) | Shank clearance in the top piece if the joint should clamp |
| #8-32 machine screw (UNC) | 0.1640 in | 32 TPI | #29 tap drill (0.1360 in) | B18.2.8 normal: #9 (0.196 in) |
| #8-36 machine screw (UNF) | 0.1640 in | 36 TPI | #29 tap drill (0.1360 in) | Same clearance as #8-32 (the hole follows diameter, not pitch) |
| #8 Type AB sheet-metal screw | 0.164 in | 18 TPI typical | Maker’s recommended sheet hole, not a UNC tap drill | Only if the sheet is a clearance part, not the tapped sheet |
Basic diameter 0.164 in is 0.060 + 8 × 0.013. Threads and holes must match the product. A #8 drywall screw is usually a coarse or fine bugle-head tapping screw for gypsum, not a #8-32 machine screw.
If you need to tap a machine thread, open the 8-32 tap drill page. If you need a wood lead hole, open the pilot hole size chart. If the #8 should pass through a plate and nut up on the far side, open the clearance hole chart.
Sources
- ASME B18.6.1 for #8 wood-screw diameter and 15 TPI.
- ASME B1.1 / B18.6.3 for #8-32 UNC and #8-36 UNF (basic diameter 0.1640 in) and the usual #29 tap drill.
- ASME B18.2.8 for the #8 close / normal / loose clearance holes.
- ASME B18.6.4 for Type AB tapping-screw pitch (typically 18 TPI on #8).
Disclaimer: These pages are reference charts and planning tools only. They are not a substitute for the published standard, a manufacturer's installation instructions, or an engineer's specification. Torque figures are advisory estimates, not values prescribed by ISO 898-1. US customary charts and UK-only fixing names are kept on separate pages and are never mixed into the same rule. Bolt Reference does not sell fasteners, inspect joints, or certify assemblies.